Skoda Rapid NH 2013 Maintenance, Workshop Manual page 160

Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
WARNING
♦ Vehicles with variable service intervals (QI6) by default
are automatically recoded to fixed service intervals as a
result of this procedure.
♦ The coding can only be reset to variable service intervals
(QI6) with the -VAS- if the following conditions are met
⇒ "6.11 Changing the code of the service intervals", page
157 .
• The service interval display for an oil change service must
be reset on changing the oil
• During the inspection, the service interval display must be
reset for the inspection
• During the oil change associated with the inspection, both
service interval displays must be reset.
For vehicles equipped with the KESSY system:
• Close all vehicle doors.
• Close tailgate and front flap.
Resetting the "oil service" indicator
– Press and hold the -1-
– Switch on ignition.
– Hold down the button -1-
is displayed in the instrument cluster:
Reset oil service?
– Release button -1-
0.0/SET
The following message is displayed in the instrument cluster:
Service reset
The "Oil service" display is reset.
Reset "inspection" display
Note
Messages "Reset oil service" and "Reset inspection" immedi‐
♦
ately follow each other .
Select the correct display for resetting.
♦
If the procedure for selecting the correct display needs to be
♦
repeated, wait around 60 s after switching off the ignition until
the information in the display -2- goes away. Afterwards, press
the button again.
0.0/SET
– Press and hold the -1-
156
6. Electrical System
⇒ page 156 .
⇒ page 156 .
button.
0.0/SET
until the following message
0.0/SET
, press again and hold.
button.
0.0/SET