Checking The Fog Lights; Replacing The Own Power Supply Of The Alarm System; Switch Off Battery Transport Mode - Skoda Rapid NH 2013 Maintenance, Workshop Manual

6.14

Checking the fog lights

Note
The headlight setting change is a repair measure.
♦
Headlight adjustment is charged separately.
♦
Inspecting the headlight beam setting
– Check whether the light/dark limit touches the adjusting line
and runs horizontally over the total width of the control screen.
Inclination value:
The inclination is -2.1 %. The fog lights must be set to this value.
Setting the headlight beam
Note
The headlight setting change is a repair measure.
♦
Headlight adjustment is charged separately.
♦
– Fit a screwdriver with socket extension or socket wrench SW
6 through the slot in the grid above the fog light.
Note
Pay attention to the correct sinking of the socket wrench in the
adjusting screw. It is guided into the adjusting screw with the cone
point of this screw.
– Adjust fog light with a screwdriver with socket extension or with
a socket wrench SW 6 by turning -arrows- the adjusting screw.
6.15 Replacing the own power supply of the
alarm system
– Replace alarm horn for warning system ⇒ Electrical system;
Rep. gr. 96 ; Anti-theft alarm system; Removing and installing
alarm horn - H12- .
6.16

Switch off battery transport mode

The active transport mode is displayed with the lettering "TrA" in
the lower display area of the dash panel insert.
Additionally the voltage value is displayed behind the lettering
"TrA".
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
161
6. Electrical System