Changing The Code Of The Service Intervals; Inspecting The Headlight Beam Setting - Skoda Rapid NH 2013 Maintenance, Workshop Manual

– Switch on ignition.
– Hold down the button -1-
is displayed in the instrument cluster:
Delete inspection?
– Release button -1-
0.0/SET
The following message is displayed in the instrument cluster:
Service reset
The "Inspection" display is now reset.
6.11 Changing the code of the service inter‐
vals
These tasks are performed with the vehicle diagnosis, measure‐
ment and information system -VAS- with corresponding diagnos‐
tic cable ⇒ Vehicle diagnostic tester.
– On the diagnostic unit, select: "Test plan" → "Bodyshell" →
"Electrical system" → "01 Self-diagnosable systems" → "Dash
panel insert - J285" → "Functions of the dash panel insert" →
"17- Service events" and next "Change fixed/variable inter‐
vals".
– Continue to follow the instructions on the diagnostic unit.
WARNING
Note the following conditions when coding the service inter‐
vals:
Vehicles with QI6 (variable service intervals) by default can be
recoded under the following conditions to fixed service intervals:
• Complete for "oil change service" or "inspection" with engine
oil change.
• Carry out the recoding using the diagnosis device.
Back-coding to variable service intervals is possible if the condi‐
tions are observed:
• Complete for "oil change service" or "inspection" with engine
oil change.
• Carry out the recoding using the diagnosis device.
• Use prescribed engine oil.
• Vehicle meets prescribed specifications (original battery...).
WARNING
Vehicles with fixed service intervals (QI1 - QI4) by default can‐
not be recoded to QI6 (variable service intervals)!
6.12

Inspecting the headlight beam setting

Special tools and workshop equipment required
♦ Headlight beam setting device
In principle the following inspection and setting description ap‐
plies for all countries. However, comply with national guidelines
until the following message
0.0/SET
, press again and hold.
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
157
6. Electrical System