Service Interval Display; Setting The Clock; Gear Recommendation; Auto Check Control - Skoda Rapid Spaceback Owner's Manual

Door alarm

Service interval display

Outside temperature
4
Speed regulating system / speed limiter
5
Total distance travelled
Distance travelled by resetting the memory (trip)
6
Time
7

Warning lights of the START-STOP system

8

Engaged gear / gear recommendation

Selector lever positions for the automatic gearbox

Outside temperature
9
Warning lights
Driving data (multifunction display)
Total distance travelled
10
Distance travelled by resetting the memory (trip)
Speed regulating system / speed limiter
Service interval display
Information messages
Fuel gauge
11
Door, luggage compartment and bonnet alarm
When the door or luggage compartment / bonnet is open, a graphic warning
appears in the display.
An acoustic signal will also sound if you drive the vehicle above 6 km/h when a
door is open.
Reset counter for distance travelled (trip)
›
Press button » Fig. 22 on page 38.
A

Setting the clock

38
Using the system
Fig. 22
Button in the instrument cluster
›
Switch on the ignition.
›
Press and hold the » Fig. 22
A
›
Release the button and the system switches to the hour setting function.
A
›
Press the button again and set the hours.
A
›
Wait around 4 seconds - the system switches to the minutes setting.
›
Press the button again and set the minutes.
A
›
Wait around 4 seconds - the system switches to the initial setting.
The time can also be set in Infotainment

Gear recommendation

A suitable engaged gear or, where appropriate, a recommended gear is dis-
played, with the aim of conserving the life of the engine and increasing driving
efficiency.
Display » Fig. 23
Optimal gear engaged

Gear recommendation (e.g.    means that it is advantageous to switch

from 3rd to 4th gear)
For vehicles with automatic transmission the recommended gear will be
shown provided the mode for manual switching (Tiptronic) is selected.
WARNING
The driver is always responsible for selecting the correct gear in different
driving situations (e.g. when overtaking).

Auto Check Control

Certain functions and conditions of individual vehicle systems are checked
continuously when the ignition is switched on. If there is a fault in the system,
the following message will appear in the display of the instrument cluster.
button until the time is shown in the display.
» Owner´s Manual - Infotainment.
Fig. 23
Information on the selected
gear / Gear recommendation
