Skoda Rapid NH 2013 Maintenance, Workshop Manual page 176

Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
– Set the position of the windscreen wiper arms in such a way
that the window edge maintains the dimension -a- and -b-.
a - 27 +2/-2 mm
b - 28 +1/-3 mm
The specified tightening torque for the windscreen wiper nut is 20
Nm.
Replacing the windscreen wiper blades
– Set the service position of the windscreen wiper arms ⇒ Op‐
erating instructions .
– Loosen the wiper blade by pressing the lock -1- in the wiper
arm -2- and pull out the wiper blade in -direction of arrow-.
– Push the standard wiper blade into the wiper arm -2- and make
sure that it locks audibly into place in the lock -1-.
– Push the new wiper blade onto the windscreen wiper arm up
to the stop until it clicks audibly into place.
– Check whether the wiper blade is correctly attached.
– Fold back the windscreen wiper arms onto the windscreen.
Note
There is a risk of damage to the windscreen by the windscreen
wiper arm, if the windscreen wiper is improperly handled.
– Adjust windscreen wiper arms to their original position ⇒ Op‐
erating instructions .
Rear window wiper arm: check and adjust home position
The specified tightening torque for the windscreen wiper nut is 12
Nm.
– Set the position of the windscreen wiper arm in such a way
that the window edge maintains the dimension -a-.
For Sedan vehicles
a = 42 ± 2 mm
172
7. Body