Replacing Engine Oil Filter For Diesel Engines Up To My 2015 - Skoda Rapid NH 2013 Maintenance, Workshop Manual

3.4.2 Replacing engine oil filter for petrol en‐
gines starting from MY 2016
Special tools and workshop equipment required
♦ Old oil collection and suction device, e.g. - VAS 6622-
♦ Oil filter wrench e.g. 3417 , or wrench 32 or 36
• Noise insulation removed
Remove replacement oil filter
– Loosen oil filter -arrow- with oil filter wrench - 3417- .
– Unscrew oil filter.
Install new replacement oil filter
– Clean sealing surface at engine.
– Lightly moisten the rubber seal of the new filter with oil.
– Screw in the new oil filter.
– Tighten the oil filter -arrow- with an oil filter wrench - 3417- to
the required torque.
Tightening torque
Oil filter
– Drain and fill with engine oil
⇒ "3.10.2 Vehicles with a petrol engine; draining and topping
up with engine oil, starting from MY 2016", page 66
– After filling with oil, run engine until it is at operating tempera‐
ture and inspect for tightness.
3.4.3 Replacing engine oil filter for diesel en‐
gines up to MY 2015
Special tools and workshop equipment required
♦ Oil filter wrench e.g. 3417 , or wrench 32 or 36
– Unscrew the plug -arrow-.
– Slacken solenoid valve -N345- -1- with holder and place to the
side.
– Slacken cable -2- and place to the side.
– Loosen the screw cap for the oil filter -1- and keep in this po‐
sition for a few minutes to allow the engine oil to flow out of the
filter element and filter housing.
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
.
Nm
20
57