Replace Engine Oil Filter - Skoda Rapid NH 2013 Maintenance, Workshop Manual

♦ for fuel system,
♦ for cooling and heating system
♦ for oil system
♦ for air conditioning system
♦ for suction and air system
♦ for exhaust system
♦ for brake system
⇒ "5.3 Inspecting brake system for leaks and damage",
page 118
- Inspect gearbox or final drive for leaks (e.g. inspection and
drain plug, shift linkage, drive shafts)
⇒ "4.1 Check final drive and joint boots for leaks and damage",
page 111 .
3.4

Replace engine oil filter

⇒ "3.4.1 Replacing engine oil filter for petrol engines up to MY
2015", page 55
⇒ "3.4.2 Replacing engine oil filter for petrol engines starting from
MY 2016", page 57
⇒ "3.4.3 Replacing engine oil filter for diesel engines up to MY
2015", page 57
⇒ "3.4.4 Replacing engine oil filter for diesel engines starting from
MY 2016", page 58
3.4.1 Replacing engine oil filter for petrol en-
gines up to MY 2015
Special tools and workshop equipment required
♦ Oil filter wrench e.g. 3417 , or wrench 32 or 36
- Remove engine cover.
Vehicles with replacement oil filter
- Loosen oil filter and unscrew.
Install new replacement oil filter
- Clean sealing surface at engine.
- Lightly moisten the rubber seal of the oil filter with oil.
- Screw in the new oil filter.
- Tighten the oil filter as follows:
Motors with identification letters CBZA, CBZB: 20 Nm.
All other engines: tighten by hand.
- After filling with oil, run engine until it is at operating tempera-
ture and inspect for tightness.
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
55