Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
Caution
♦ A lit exhaust emissions warning lamp in the dash panel
insert indicates an error in the exhaust-related systems.
These faults (including sporadic ones) are stored in event
memory.
♦ The idling speed, CO content and lambda value are only
measured and they cannot be adjusted.
♦ The CO content is influenced by the lambda control. Faults
in the Lambda control are indicated by an exhaust emis‐
sions warning lamp in the dash panel insert; faults are
stored in event memory.
Resolve all identified exhaust-related faults, including sporadic
faults, when reading the event memory, before the exhaust
emissions
test
⇒ "6.7 Connect diagnostic unit", page 145
After deleting the event memory, the readiness code must be
re-generated. The best way to do this is via a test drive or using
the vehicle diagnosis tester.
Test conditions for vehicles without EOBD
•
Faultless function of the engine without extraordinary inequal‐
ities in the engine running behaviour.
•
Oil temperature at least 80 °C
•
Perfect operation of the ignition system
•
Intake system tight
•
Event memory (01- Engine electronics) is not read
Connect the test equipment to the vehicle
DANGER!
To prevent industrial accidents or avoid causing damage to the
ignition system, pay attention to the following:
♦ Disconnect and connect wires of the ignition system (in‐
cluding high-voltage wires) when the ignition is switched
off.
– Connect the tester in compliance with the Owner's Manual.
Connect the diagnostic unit to the diagnostic connector
⇒ "6.7 Connect diagnostic unit", page 145
Note
The exhaust gas probe must be fully inserted into the exhaust
tailpipe (do not insert into the suction tube)!
– Start engine and run in idle.
– Perform the exhaust-emission analysis.
180
8. Exhaust-emission analysis
(repair
procedure)
.
.