Skoda Rapid NH 2013 Maintenance, Workshop Manual page 129

– Fit bleeder hose -1- of catch pan onto the bleeder valve of the
rear right wheel.
Note
Slacken the bleeder valves using the set of tools for brake
♦
bleeding - VAS 6564- and tighten. While doing so, pull the
bleeder hose through the socket insert with a corresponding
hollow adapter piece from this set.
Fit a torque wrench on the socket insert with a corresponding
♦
hollow adapter piece for tightening the vent valve.
– Loosen the bleeder valve and allow approx. 0.3 litres of brake
fluid to flow out.
– Tighten bleeder valve to corresponding tightening torque ⇒
Brake systems; Rep. gr. 47 .
– Detach hose of catch pan.
– Fit the rubber cap onto the bleeder valve and remove the catch
pan from the vehicle.
– Repeat this procedure for all brake calipers/wheel-brake cyl‐
inders.
Sequence for bleeder valves:
Slave cylinder (manual gearbox only)
Wheel brake cylinder/brake calliper
Brake caliper
Total volume, automatic gearbox
Total volume, manual gearbox:
– Switch off and disconnect the brake filling and bleeding de‐
vice .
– Check brake fluid level
⇒ "5.5 Brake fluid level: check.", page 126
onto the brake fluid reservoir.
– Activate the brake pedal repeatedly.
– Check that the pedal "does not fall through" when it is pressed
down repeatedly with force.
– Check the brake pedal-idle travel on the brake pedal. Idle trav‐
el: max. 1/3 of pedal travel.
– Perform a test drive.
Note
During a test drive, at least one ABS adjustment must be carried
out on vehicles with ABS.
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Volume of brake fluid which must flow out of the vent
Rear right
Rear left
Front right
Front left
and screw the cap
Maintenance - Edition 06.2018
valves:
0.15 l
0.30 l
0.30 l
0.20 l
0.20 l
approx. 1.00 l
approx. 1.15 l
125
5. Chassis