Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
– Push the coolant pipe out of the air filter housing -5- and de‐
posit on the side.
– Disconnect the connector -3- on the air mass meter - G70- .
– Release the spring clip -4- and pull the air hose off the air mass
meter - G70- .
– Pull off -2- air filter housing upwards from the ball pin.
– Remove air filter housing -2- and lay aside turned by 180°.
– Disconnect the intake manifold from the air filter housing.
– Unscrew the screws -1- from the air filter lower part.
– Remove air filter top part and take out air filter element.
Installing
– Make sure that the housing, air mass meter, and water drains
are not soiled; clean if needed
⇒ "3.15.7 Cleaning air filter housing", page 101
– Insert the air filter element -2- into mount on the air filter upper
part -1-.
100
.