Skoda Rapid NH 2013 Maintenance, Workshop Manual page 156

Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
WARNING
When resetting the service interval display with vehicle diag‐
nosis, measurement and information system -VAS- , note the
following:
Remove the checkmark at the "work with targeted fault finding"
function for the vehicle identification on the display of the ve‐
hicle diagnostic tester.
The display of the vehicle diagnosis tester displays the follow‐
ing "Now targeted fault finding has been cancelled, only targe‐
ted functions and self-diagnosis are available. Would you like
to perform a diagnosis without targeted fault finding?"
Confirm function with "Yes".
• When changing the engine oil, the service interval display
must be reset for the engine oil change.
On the diagnostic unit, then select: "Dash panel insert - J285"
→ "Functions of the dash panel insert" → "17- Service events"
and next "Oil change service (variable)" → or "Oil change serv‐
ice".
Continue to follow the instructions on the diagnostic unit.
• During the inspection, the service interval display must be
reset for the inspection.
On the diagnostic unit, then select: "Dash panel insert - J285"
→ "Functions of the dash panel insert" → "17- Service events"
and next "Examination" or "Inspection".
Continue to follow the instructions on the diagnostic unit.
• During the inspection associated with the engine oil
change, both service interval displays must be reset.
Reset the service interval display with the buttons on the dash
panel insert
When resetting the service interval display using the buttons in
the dash panel insert, observe the following information:
WARNING
This work sequence cannot be carried out on vehicles, for
which no service message or only a pre-warning was displayed
on the display of the dash panel insert.
Reset "oil change service" display
WARNING
♦ Vehicles with variable service intervals (QI6) by default
are automatically recoded to fixed service intervals as a
result of this procedure.
♦ The coding can only be reset to variable service intervals
(QI6) with the -VAS- if the following conditions are met
⇒ "6.11 Changing the code of the service intervals", page
157 .
152
6. Electrical System