Skoda Rapid NH 2013 Maintenance, Workshop Manual page 187

Test conditions for vehicles with EOBD
• Faultless function of the engine without extraordinary inequal‐
ities in the engine running behaviour.
• Oil temperature at least 80 °C
• Air conditioning switched off
• The readiness code is generated for all exhaust gas systems
and components according to homologation. The exhaust
emissions warning lamp in the dashpanel insert does not dis‐
play an error.
• If the readiness code was not generated, it will need to be
generated. The best way to do this is via a test drive or using
the vehicle diagnosis tester. If necessary, check why the sys‐
tem or components has not yet been tested while the vehicle
is moving.
• No fault from the exhaust-related systems is stored in event
memory (the exhaust emissions warning lamp in the dash
panel insert does not indicate a fault) – query the event mem‐
ory ⇒ "6.7 Connect diagnostic unit", page 145
Caution
♦ A lit exhaust emissions warning lamp in the dash panel
insert indicates an error in the exhaust-related systems.
These faults (including sporadic ones) are stored in event
memory.
Resolve all identified exhaust-related faults, including sporadic
faults, when reading the event memory, before the exhaust
emissions test
⇒ "6.7 Connect diagnostic unit", page 145
After deleting the event memory, the readiness code must be
re-generated. The best way to do this is via a test drive or using
the vehicle diagnosis tester.
Test conditions for vehicles without EOBD
• Faultless function of the engine without extraordinary inequal‐
ities in the engine running behaviour.
• Oil temperature at least 80 °C
• Air conditioning switched off
• Event memory (01- Engine electronics) is not read
Connect the test equipment
– Connect the tester in compliance with the Owner's Manual.
Connecting the diagnostic unit to the diagnostic connector
⇒ "6.7 Connect diagnostic unit", page 145
– Start the engine, allow it to warm up to the operating temper‐
ature (the best way is to drive it) and allow it to run in idle.
– Perform the exhaust-emission analysis.
.
(repair procedure)
.
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
8. Exhaust-emission analysis
183