Replace Ocu Control Unit; J949 ); Era Glonass: Check That The Emergency Call System Is Ready - Skoda Rapid NH 2013 Maintenance, Workshop Manual

6.18 Replace OCU control unit ( control unit
for emergency call module and commu‐
nication unit - J949- )
– Remove OCU control unit ( control unit for emergency call
module and communication unit - J949- ) ⇒ Electrical System;
Rep. gr. 91 ; Mobile online services .
– Install new OCU control unit ( control unit for emergency call
module and communication unit - J949- ) ⇒ Electrical System;
Rep. gr. 91 ; Mobile online services .
6.19 ERA Glonass: check that the emergen‐
cy call system is ready
The ERA Glonass system control is located in the front roof trim
near the interior lights.
WARNING
To check the ERA Glonass emergency call system is ready for
operation, you must first deactivate transport mode
⇒ "6.16 Switch off battery transport mode", page 161
The OCU control unit ( control unit for emergency call module
and communication unit - J949- ) is activated for sending at the
same time as transport mode is switched off.
– Switch on ignition.
WARNING
• To check that the emergency call system is ready for op‐
eration, you must switch on the ignition continuously for at
least approx. 15 minutes.
– Check colour of ERA Glonass system status LED.
The status LED -2- of the ERA Glonass system is lit read for ap‐
prox. 4 seconds after ignition is switched on.
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
.
163
6. Electrical System