Skoda Rapid NH 2013 Maintenance, Workshop Manual page 170

Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
– Open "SOS" cap in -direction of arrow-.
1 - Emergency call button
2 - Status LED
3 - Button for test emergency call
– Press the button for test emergency call -3- for 3 seconds (e.g.
with pin).
Pressing the button for test emergency call -3- activates the voice
prompts for the test sequence.
The following component are check by the system test:
♦ OCU unit, SW integrity and realtime
♦ GNSS (GPS) aerial
♦ GSM aerial
♦ Microphone
♦ Loudspeaker
♦ Connection of the unit with other components (BUS commu‐
nication, airbag)
♦ Connection of HMI components
♦ Button -1- in the control element
♦ Condition of the emergency battery
– Follow the voice prompts.
Confirm each step of the test by pressing the button -1-.
A voice prompt and flashing green status LED -2- confirms that
the test sequence has been completed successfully.
WARNING
♦ A voice prompt and flashing status LED -2- indicate if the
test sequence has failed.
♦ Evaluation of the failed test sequence (flashing status LED
-2-) ⇒ Electrical System; Rep. gr. 91 ; Mobile online serv‐
ices .
The next step after the test sequence fails is to perform a re‐
pair.
Work procedure after failed test sequence:
– Query event memory with the vehicle diagnosis, measurement
and information system -VAS-
⇒ "6.7 Connect diagnostic unit", page 145
Once the event memory has been queried and you have com‐
pleted any repair ⇒ Electrical System; Rep. gr. 91 ; Mobile online
services :
– Repeat the test by pressing the button -3- for 3 seconds.
– Also follow the voice prompts (to complete the test sequence
correctly).
166
6. Electrical System
.