Validating A Soundstructure Voip Interface Installation - Polycom SoundStructure C16 Design Manual

Design Guide for the Polycom SoundStructure C16, C12, C8, and SR12

Validating a SoundStructure VoIP Interface Installation

12 - 60
Click Continue when prompted.
Finally, you will see a message confirming the server has been cleared.
Once you have completed your SoundStructure configuration file, have
uploaded the configuration file to the SoundStructure system, and configured
the SoundStructure VoIP Interface, you can validate your installation with the
following steps:
1. Confirm Version 1.7.0 or newer of SoundStructure Studio is used.
2. Confirm Version 1.5.0 or newer SoundStructure firmware is used.
3. Confirm a SoundStructure VoIP Interface channel is defined in the
project.
4. Confirm the VoIP Status on Wiring page is 'ok'.
5. Confirm the SoundStructure VoIP Interface has a valid IP address.
6. Confirm there is a valid network route to the SoundStructure VoIP
Interface.
7. Confirm the line is registered - or dial a SIP URL call to confirm the
SoundStructure VoIP Interface card has been installed properly except for
line registration settings.
8. Confirm a call can be dialed using the registered line.
These steps are described in more detail in the following sections.
Version 1.7.0 or Newer of SoundStructure Studio Used
Version 1.7.0 SoundStructure Studio software is required for connecting to a
SoundStructure system that has firmware version 1.5.0 or newer and has a
SoundStructure VoIP Interface card installed.