How To Read This Chapter - Polycom SoundStructure C16 Design Manual

Design Guide for the Polycom SoundStructure C16, C12, C8, and SR12

How to Read This Chapter

12 - 2
Interface offhook, dial digits, put calls on hold, resume calls, and more. A typ-
ical call and control scenario with the user interacting with the touch screen is
shown next.
VoIP Network
This chapter describes in detail how to create a fully functional SoundStruc-
ture VoIP Interface-based system. From a high-level perspective, there are
only a few things that need to be done once you have the proper firmware and
version of SoundStructure Studio:
1. Create a SoundStructure Studio project with the SoundStructure VoIP
Interface by creating a new project or upgrading an existing project.
2. Install the SoundStructure VoIP Interface plug-in card into the
SoundStructure system.
3. Give the MAC address of the SoundStructure VoIP Interface to the
IT/Phone team and receive the SIP server IP address and VoIP phone line
registration information.
4. Enter the SoundStructure VoIP Interface the SIP server IP address and
line registration information from the Web UI of the SoundStructure VoIP
Interface
5. Make a test call to confirm the line is properly registered to the SIP server.
The rest of the chapter explains these step in detail.
Use the following table to decide which section will help you.
If you...
Have an existing system with a TEL1 or
TEL2 and want to upgrade to a
SoundStructure VoIP Interface
Want to create a new project with a
SoundStructure VoIP Interface
Want to dial a call or change the phone
settings using SoundStructure Studio
SoundStructure
VoIP Interface
Up to 24 Single conference
call appearances or call appearance
4148
1 2 3
Dial 4 5 6
7 8 9
0 #
*
Touch Screen
Then see...
Upgrading an Existing TEL1/TEL2
Project to the SoundStructure VoIP
Interface
Creating a New Project with the
SoundStructure VoIP interface
Using the SoundStructure VoIP
Interface with SoundStructure Studio
Sound
Structure
Control System