Configuring The Soundstructure Voip Interface - Polycom SoundStructure C16 Design Manual

Configuring the SoundStructure VoIP Interface

Setting the IP address of the SoundStructure VoIP Interface
After sending the configuration file to the SoundStructure system, the result-
ing system will have t will have a solid green front panel LED to indicate that
the configuration file that is loaded matches the hardware and SoundStructure
Studio project status will be solid green as shown next.
The system is now ready for the final online setup required by the SoundStruc-
ture VoIP Interface to register with the desired call platform.
Once the SoundStructure VoIP Interface is installed in the SoundStructure sys-
tem, you need to configure the SoundStructure VoIP Interface for your call
management environment with the following steps:
1. Set the IP address of the SoundStructure VoIP Interface. An IP address is
required to access to the Web Configuration Utility.
2. Set the Provisioning Server settings. A provisioning server can be used to
store the configuration parameters of the SoundStructure VoIP Interface
and for upgrading the firmware on the SoundStructure VoIP Interface.
If a provisioning server is not being used, the Web Configuration Tool
must be used.
3. Configure the Call Server IP address so the SoundStructure VoIP
Interface knows where to try to register its lines.
4. Register the line(s). The line registration information configures the
extensions and authentication credentials required by the call server.
Details of these steps are in the following sections.
The VoIP-specific settings described above can only be set while working
online with the SoundStructure VoIP Interface.
This section describes the default IP address settings of the SoundStructure
VoIP Interface and how to set the IP address.
The SoundStructure VoIP Interface
12 - 21