Uploading The Configuration File - Polycom SoundStructure C16 Design Manual

Design Guide for the Polycom SoundStructure C16, C12, C8, and SR12

Uploading the Configuration File

12 - 20
Connect Network to the SoundStructure VoIP Interface
Connect the network interface of the SoundStructure VoIP Interface to the
appropriate VoIP network as shown in the following figure.
Power Up the System
Once the plug-in cards are properly installed, plug-in the power cord to the
devices. Unless the system is in a factory-fresh state, after the system has fin-
ished booting, it will have a solid yellow front panel LED to indicate that the
configuration file that is loaded does not match the hardware. To correct the
yellow front panel LED status you will upload the proper configuration file in
the next step.
Now that the SoundStructure system has the appropriate plug-in cards
installed, the upgraded project must be sent to the SoundStructure system
with the following steps:
1. Left-click on the System Name to select the upgraded configuration file
that was created previously.
2. Connect to the SoundStructure system by selecting the Connect option
and Search for Devices.
3. Select Send configuration to devices and then click Connect.
4. Confirm that you would like to send the configuration file to the system.
0004F2BF001D
LAN C-LINK2
OBAM IR
IN OUT 12V