Removing Events With Studio - Polycom SoundStructure C16 Design Manual

Removing Events With Studio

SoundStructure Studio Automatically Creates Events
Events may be removed by selecting one or more events and choosing the
Remove Event button on the events page.
When a new project is created, SoundStructure Studio will automatically
create events depending on the input and output options selected. For
example,
• If an HDX codec is added to a project, new events for volume control and
mute are created. These new events replace the pre-1.3 requirement to use
the virtual channel names "Mics" and "Amplifier".
• If PSTN interfaces are added to a project, events for tracking the call active
state (onhook/offhook) are created.
• If push-to-talk microphones are added, events for muting the
microphones and for illuminating status LED's are created.
• If an HDX IR remote is selected, events mapping the key presses on the IR
remote to the appropriate functions within SoundStructure are created.
Backwards Compatibility with earlier SoundStructure firmware
As described in this section, SoundStructure device firmware 1.3 uses events
to handle the muting and volume control integration between an HDX and a
SoundStructure device. In pre-1.3 versions of SoundStructure firmware, the
names "Mics" and "Amplifier" were required for integrating the HDX Mute
and Volume control to SoundStructure devices. If those names were not
defined in the SoundStructure device, the HDX was not able to control the
SoundStructure device.
SoundStructure device version 1.3 firmware uses a different and better way to
handle the HDX muting and volume control.
1. If there are no events defined for the SoundStructure device, the earlier
firmware behavior is retained and the names "Mics" and "Amplifier" are
required for the HDX to control the SoundStructure device. This
backward compatibility mode means that the SoundStructure system will
behave as it did prior to the firmware upgrade when there were no events
defined.
2. When the SoundStructure device is upgraded to the 1.3 or later firmware,
defining any events using the Add Events feature will cause
SoundStructure Studio to automatically create the necessary
SoundStructure events for the HDX and SoundStructure device
integration.
Using Events, Logic, And IR
9 - 7