Installing The New Plugin Cards - Polycom SoundStructure C16 Design Manual

Installing the New Plugin Cards

6. Once the firmware has been updated, the SoundStructure system will
automatically reboot and SoundStructure Studio will display the Connect
to Devices dialog. Close the Connect to Devices dialog and wait for the
SoundStructure system to reboot. The SoundStructure front panel light
will blink green while the system is booting and will turn solid green
when the system has finished rebooting.
Once the SoundStructure system has the appropriate firmware loaded, the
next step is to power down the system and install (or replace) the plug-in cards
with the newly selected cards.
Power Down the System
To power down the system, remove the power cord from the rear of the
SoundStructure system. If there are multiple devices in a system, remove
power from all the devices.
Install Plug-in Cards
Remove any existing plug-in cards that were replaced with the Upgrade
Plug-in Card Tool and replace with the new plug-in cards. The following
figure shows a SoundStructure TEL1 being replaced with a SoundStructure
VoIP Interface.
LAN
PHONE
C-LINK2
IN
PHONE
0004F2009EFF
LAN C-LINK2 IN
The SoundStructure VoIP Interface
LINE
PIN 2: TXD
PIN 3: RXD
PIN 5: GROUND
PIN 7: CTS
PIN 8: RTS
RS-232
OBAM IR
OUT 12V
LINE
PIN 2: TXD
PIN 3: RXD
PIN 5: GROUND
PIN 7: CTS
PIN 8: RTS
RS-232
OBAM IR
OUT 12V
12 - 19