Automatic Power-Up Connector; Board Power-Supply Connector - Matrox Supersight Installation And Hardware Reference

Pinout descriptions of internal Matrox Supersight SHB-5520 connectors

Automatic power-up connector

The automatic power-up connector on the Matrox Supersight SHB-5520 board
is a 2-pin standard, 2 mm spacing, male connector. It allows you to automatically
power the SHB upon power up of your Matrox Supersight unit. You must install
a jumper on this connector when the Matrox Supersight SHB-5520 is located in
SHB connectors 2, 3, or 4 of a Matrox Supersight e2 unit.
Jumper Description
Installed SHB will automatically power up when your Matrox Supersight powers up.
Not installed SHB will not power up.

Board power-supply connector

The board power-supply connector on the Matrox Supersight SHB-5520 board
is an 8-pin, EPS 12 V male, board power-supply connector. This connector
receives power from the Matrox Supersight unit power source.
Pins Description
1, 2, 3, 4 Ground
5, 6, 7, 8 Power (+12 V DC)
1 2 3 4
5 6 7 8
97