Table of Contents
Advertisement
Pinout descriptions of internal Matrox Supersight SHB-5520 connectors
USB header
The USB header is a standard, 2 mm spacing,10-pin male connector. It is used to
connect two additional 4-pin USB devices (such as USB keyboards), or one USB
flash module using a custom adapter bracket.
The pinout of the USB header for Matrox Supersight SHB-5520 is as follows:
Pins
1, 2
3, 4
5, 6
7, 8
9, 10
Serial port headers
The two serial port headers are standard, 2 mm spacing, 10-pin male connectors.
To access these connectors from outside the chassis, use a custom adapter bracket.
The RS-232 serial ports are capable of sending and receiving information to and
from local devices; the driver and the receiver of which are always enabled. Each
port is controlled by a universal asynchronous receiver-transmitter (UART)
device, which converts serial data into parallel data when receiving information.
Conversely, when transmitting information, the UART converts parallel data to
2
1
10
9
Signal
VCC
USB-
USB+
GND
No connection.
9
1
10
2
95
Advertisement
Table of Contents
