Table of Contents
Advertisement
136 Appendix C: BIOS reference for Matrox Supersight SHB-5520
Item
Options
Memory Ch 0 Slot 0
Memory Ch 1 Slot 0
Memory Ch 2 Slot 0
Memory Ch 0 Slot 0
Memory Ch 1 Slot 0
Memory Ch 2 Slot 0
Warning
Item
Options
SMBus Controller
Disabled
Enabled*
GbE Controller
Disabled
Enabled*
Wake on LAN from S5
Disabled*
Enabled
DIMM Information sub-submenu
The DIMM information sub-submenu allows you to configure the settings of the
six SO-DIMM memory modules.
Meaning
Node 0 Information:
These items report if a memory module is present in each slot, the memory capacity of the module, and the
type of module (for example, Present 2048 MB DDR3).
Node 1 Information:
These items report if a memory module is present in each slot, the memory capacity of the module, and the
type of module (for example, Present 2048 MB DDR3).
South Bridge Configuration submenu
The South Bridge Configuration submenu allows you to configure settings for
the ICH10R chip.
Setting the items below to the wrong values can cause the unit to malfunction.
Meaning
This item allows you to enable the System Management Bus (SMBus) controller.
Note that the default setting of this value is optimized for the Matrox Supersight SHB-5520 board.
❖
This item is reserved.
Note that the default setting should not be changed.
❖
This item allows you to start the unit from the S5 (power off) state from a remote computer.
Note that Microsoft Windows NT and Microsoft Windows 95 do not support Wake on LAN from S5.
❖
Microsoft Windows 98, Microsoft Windows Me, Microsoft Windows 2000, Microsoft Windows XP , and
Microsoft Windows 7 for Embedded Systems 64-bit support Wake on LAN from S5.
Advertisement
Table of Contents
