Matrox Supersight Installation And Hardware Reference page 60

60 Chapter 3: Connecting devices to the backplane and to the Matrox Supersight SHB-5520 board
10. Connect the SATA LP4 power connector to one of the 4-pin peripheral power
11. Re-install the DVD enclosure to the tray using the screws.
12. Re-install the drive-tray to the chassis by reversing the steps described in the
13. Re-install the chassis cover by reversing the steps described in the Removing the
14. Reconnect the power source to the unit, and restart each Matrox Supersight
9. Connect the SATA cable connector from the back of the DVD drive to the
specified SHB.
SATA connector
SATA plus power connector
(connect to back of the DVD drive)
cables of your Matrox Supersight unit's power supply. Always use the shortest
power cable possible to connect the mass storage device to your Matrox Supersight
backplane. This helps avoid having cables getting squeezed or worn.
Removing the drive-tray, earlier in this chapter.
chassis cover, earlier in this chapter.
SHB-5520.
Power connector