Matrox Supersight Installation And Hardware Reference page 62

62 Chapter 3: Connecting devices to the backplane and to the Matrox Supersight SHB-5520 board
Installing memory
Adjusting the new
memory settings
To install a memory module on the Matrox Supersight SHB-5520:
❖ Note that, when installing memory modules, each pair of modules should be the
same size and be installed into sequential slots.
1. Spread the clips at each end of the SO-DIMM slot.
2. Position the module over the SO-DIMM slot, such that the notch along the
module's bottom edge is aligned with the notch of the slot.
3. Gently insert the bottom edge of the module into the slot. If properly inserted,
the two clips (one on each side of the module) will close automatically.
4. Re-install the Matrox Supersight SHB-5520 in its slot by performing the steps
described in the Adding boards to the backplane, earlier in this chapter.
5. Re-install the retainer guides by reversing the steps described in the Removing the
retainer guide subsection, earlier in this chapter.
6. Re-install the chassis cover by reversing the steps described in the Removing the
chassis cover, earlier in this chapter.
7. Reconnect the power source to the unit, and restart each Matrox Supersight
SHB-5520.
If MIL is installed on the unit, you must adjust the unit's new memory settings
using MilConfig (the MIL Configuration utility). Refer to the MIL User Guide
for more information on using this utility.