Matrox Supersight Installation And Hardware Reference page 64

64 Chapter 3: Connecting devices to the backplane and to the Matrox Supersight SHB-5520 board
10. Connect the power cord of the new chassis fan to the Matrox Supersight unit.
11. Re-attach and close the screen door.
12. Close the front panel and attach the screws.
13. Re-install the drive-tray back in the chassis by reversing the steps described in the
14. Re-install the chassis by reversing the steps described in the Removing the chassis
15. Reconnect the power source to the unit, and restart each Matrox Supersight
7. Disconnect the fan power cord from the Matrox Supersight unit.
8. Remove the chassis' fan and the protective guard on the fan.
9. Attach the new chassis' fan to the unit using the four screws and replace the
protective guard.
Installing or replacing an optical disk drive, earlier in this chapter.
cover, earlier in this chapter.
SHB-5520.