Matrox Supersight Installation And Hardware Reference page 43

connectors, if this is required. Note that when an 8-pin EPS connector is used,
the 6+2 pin power connector present on the same cable (or the two 6-pin
connectors on a connected adapter) cannot also be used.
Always use the shortest power cable possible to connect the SHB or PCIe board
to your Matrox Supersight backplane. This helps avoid having cables touch the
boards or the backplane, as well as cables from getting squeezed or worn.
8. When all boards are in place, re-align the retainer guide across the back-end of all
the boards, place any required missing pressure feet into each of the retainer guide
slots so that the bottom of each pressure foot is against the top of each installed
board, Then, install the retainer guide by reversing the steps described in the
Removing the retainer guide, earlier in this chapter.
9. Optionally, tuck unused cables beneath the drive-tray to reduce cable clutter in
the chassis. To remove the drive-tray, refer to Removing the drive-tray, earlier in
this chapter. To re-install the drive-tray into the chassis, reverse the
previously-listed steps.
10. Re-install the chassis cover by reversing the steps described in the Removing the
chassis cover, earlier in this chapter.
11. Reconnect the power source to the unit, and restart each Matrox Supersight
SHB-5520.
Adding boards to the backplane 43