Matrox Supersight Installation And Hardware Reference page 151

Type of error BIOS Message
PCI I/O Conflict
System
configuration
PCI ROM Conflict
(continued)
PCI IRQ Conflict
PCI IRQ Routing Table Error
Timer Error
Interrupt Controller-1 Error
CMOS CMOS Date/Time Not Set
CMOS Battery Low
CMOS Settings Wrong
CMOS Checksum Bad
Miscellaneous Keyboard Error
Keyboard/Interface Error
System Halted
Explanation
A PCI adapter, while being configured by the BIOS POST, has generated an input/output (I/O)
resource conflict.
The BIOS (DIM code) cannot route an IRQ to a PCI device in the unit. This error is often
caused by an incomplete description of the PCI Interrupt Routing of the unit.
An error was encountered while programming the count register for channel 2 of the 8254
timer. This can indicate a problem with the Matrox Supersight SHB-5520 board.
BIOS POST could not initialize the master interrupt controller. This can indicate a problem
with the Matrox Supersight SHB-5520 board.
The CMOS date and/or time are invalid. You can resolve this error by readjusting the time in
the BIOS Setup utility.
The CMOS battery is low. This message usually indicates that the CMOS battery needs to be
replaced. It can also appear when the user discharges the CMOS battery.
The CMOS settings are invalid. This error can be resolved using the BIOS Setup utility.
The CMOS contents failed the checksum check. The CMOS data has been changed by a
program other than the BIOS or that the CMOS is not retaining its data due to malfunction.
This error can typically be resolved using the BIOS Setup utility.
The keyboard is not present or the hardware is not responding when the keyboard controller
is initialized.
The keyboard controller failed. This might be a hardware problem.
The Matrox Supersight SHB-5520 board has halted after a fatal error has been detected. You
must reboot your SHB.
BIOS messages 151