Table of Contents
Advertisement
4.2
The Monitor Program
4.2.1
Accessing the Monitor Program
To access the Monitor program via the MON connector:
Use the Moni
1
Station to the COM port of your ASCII ANSI terminal or PC. The COM port
connector on th
Run a terminal em
2
Set the communication parameters as shown in the following table:
3
Parameter
Baud Rate
Data B
its
Stop Bits
Parity
Flow Control
Port
The passwod prompt is displayed. Ent
4
key to get to the Main menu.
NOTE
The default password is "admin".
To
access the Monitor pro
The PC used for accessing the M
1
according to the parameters configured for the applicable port (MGMT or
DATA port).
If you connect directly
2
cable.
Run the Telnet program conn
3
BreezeMAX System Manual
tor cable to connect the MON connector of the NPU/Micro Base
e Monitor cable is a 9-pin D-type plug.
ulation program, such as HyperTerminal™.
Table 4-1: COM Port Configuration
Value
9600
8
1
None
Xon/Xoff
Connecte
d COM port
gram using Telnet:
onitor program should be configured
to the MGMT or DATA port, use a crossed Ethernet
ecting to the IP address of the connected port.
er the password and press the Enter
The Monitor Program
85
Advertisement
Table of Contents
