The Monitor Program
Accessing the Monitor Program
To access the Monitor program via the MON connector:
1. Use the Monitor cable to connect the MON connector of the
NPU/Micro Base Station to the COM port of your ASCII ANSI
terminal or PC. The COM port connector on the Monitor cable is a
9-pin D-type plug.
2. Run a terminal emulation program, such as HyperTerminal™.
3. Set the communication parameters as shown in the following table:
Parameter
Baud Rate
Data Bits
Stop Bits
Parity
Flow Control
Port
4. The passwod prompt is displayed. Enter the password and press
the Enter key to get the Main menu.
NOTE
The default password is "admin".
Manual Revision 1.0
Table 4-1: COM Port Configuration
Value
9600
8
1
None
Xon/Xoff
Connected COM port
The Monitor Program
4-3