Using The Reset Button Of The Base Station; Resetting The Base Station; Returning The Base Station To Factory Default Configuration; Restarting The Unit In Rescue Mode - Alvarion WBSn-2400 System Manual

Table of Contents

Advertisement

Appendix A - TroubleshootingUsing the Reset Button of the Base Station
Appendix A - Troubleshooting
A.2

Using the Reset Button of the Base Station

The recessed Reset (RST) button is located below the USB button. To use it remove the plastic cap used
for sealing the USB connector and the RST button).
CAUTION
After using the Reset button, ensure the button and USB connector are properly sealed with the plastic
cap.
The Reset button enables the following actions:
A.2.1

Resetting the Base Station

To reset the unit during normal operation, use a sharp object to press the Reset button for a short time.
This will cause a hard-reset operation equivalent to disconnecting/reconnecting power to the unit
(Reboot actions executed from the management system cause soft-reset).
A.2.2
Returning the Base Station to Factory Default
Configuration
To return to factory default configuration press the Reset button continuously for at least 20 seconds
(but less than 40 seconds). The unit will reset and restart using the factory default configuration
(including management IP parameters).
A.2.3

Restarting the Unit in Rescue Mode

Rescue Mode is a special operation mode allowing to access the unit when it does not operate properly
for one of the following reasons:
1
Frequent power interruptions - when the power disconnects/reconnects on several concurrent
occasions within a few minutes.
2
Inability to manage the unit due to a configuration problem.
3
The firmware files in both banks are corrupted.
Under the above conditions it is impossible the access the unit using the management applications or
perform a reset.
To restart the unit in rescue mode press the Reset button continuously for at least 40 seconds. The unit
will reset and restart in rescue mode, allowing access through a simplified web interface using the
default IP address (192.168.1.1), regardless of the regular operational IP address:
WBSn-2400 and WBSn-2450 System Manual
Using the Reset Button of the Base Station
112

Advertisement

Table of Contents
loading

Table of Contents