[:Sense]:Toi Subsection - Keysight N9320B Programmer's Manual

Command Reference
SENSe Subsystem

[:SENSe]:TOI Subsection

Key access:
Key access:
134
Set the Average
[:SENSe]:TOI:AVERage:COUNt <integer>
[:SENSe]:TOI:AVERage:COUNt?
[:SENSe]:TOI:AVERage[:STATe] OFF|ON|0|1
[:SENSe]:TOI:AVERage[:STATe]?
To specify the number of measurement averages used when
calculating the measurement result set Avg Number to ON. The
average will be displayed at the end of each sweep. Setting Avg
Number to OFF disables measurement averaging.
*RST: 10/Off
Range: 1 to 1000
> Occupied BW > Avg Number On Off
Meas
Set the Average Mode
[:SENSe]:TOI:AVERage:TCONrol EXPonential|REPeat
[:SENSe]:TOI:AVERage:TCONrol?
Press Avg Mode to select the type of termination control used for
the averaging function to either Exp (Exponential Averaging mode)
or Repeat. This determines the averaging action after the specified
number of measurements (average count) is reached.
• EXP — When you set Avg Mode to Exp, each successive data
acquisition after the average count is reached is exponentially
weighted and combined with the existing average. Exponential
averaging weights new data more than old data, which
facilitates tracking of slow changed signals. The average is
displayed at the end of each sweep.
• Repeat — When you set Avg Mode to Repeat, after reaching the
average count, all previous result data is cleared and the
average count is set back to 1.
*RST: EXPonential
Example:
TOI:AVG:TCON EXP
> More > TOI > Avg Mode
Meas