Keysight N9320B Programmer's Manual page 80

Command Reference
CALCulate Subsystem
Key access:
Default Unit:
Key access:
74
Define Peak Search
:CALCulate:MARKer:PEAK:SEARch:MODE PARameter|MAXimum
:CALCulate:MARKer:PEAK:SEARch:MODE?
Sets the peak search mode.
*RST:
MAXimum
Remarks: If mode is set to MAXimum, peak search will place the marker at
the maximum amplitude in the trace. If mode is set to PARameter,
peak search will place the marker at the highest peak that rises and
falls by at least the peak excursion above the peak threshold. If no
peak meets the excursion and threshold criteria, No Peak Found is
issued.
Next peak, next peak right, next peak left, and peak table are not
affected by this command. They will always use peak excursion and
peak threshold for search criteria.
> More > Search Criteria > Peak Type > Max Value|Excursion &
Peak
Search
Threshold
Define Peak Threshold
:CALCulate:MARKer:PEAK:THReshold <ampl>
:CALCulate:MARKer:PEAK:THReshold?
Specifies the minimum signal level for the analyzers internal peak
identification routine to recognize a signal as a peak. This applies to
all traces and all windows.
:CALCulate:MARKer:PEAK:SEARch:MODE
Range: Reference level to the bottom of the display
Amplitude units
> More > Search Criteria > Peak Threshold
Peak
Search
See