Keysight N9320B Programmer's Manual page 120

Command Reference
MMEMory Subsystem
Key access:
Key access:
114
Load a Limit Line from Memory to the Instrument
:MMEMory:LOAD:LIMit LLINE1|LLINE2,'<file_name>'
Loads a limit line, from the specified file in mass storage to the
instrument. Loading a time limit line deletes any frequency limit
lines. Similarly, loading a frequency limit line deletes any time limit
lines.
Example:
:MMEM:LOAD:LIM LLINE2,'mylimit.lim'
Remarks: There is no SCPI short form for parameters LLINE1|LLINE2.
> Load > Type > Limits
File/
Print
Load an Instrument State from a File
:MMEMory:LOAD:STATe 1,'<file_name>'
The contents of the state file are loaded into the current instrument
state.
Example:
:MMEM:LOAD:STAT 1,'mystate.sta'
Remarks: This command is only available in Spectrum Analysis mode.
See also commands :MMEMory:LOAD:STATe and
:MMEMory:STORe:STATe
If the revision of the state being loaded is newer than the revision of
the instrument, no state is recalled and an error is reported.
If the revision of the state being loaded is equal to the revision of
the instrument, all regions of the state will be loaded.
If the revision of the state being loaded is older than the revision of
the instrument, the instrument will only load the older regions of
the state.
> Load > Type > State
File/
Print