Alcatel-Lucent 7750 SR Manual page 1712

Os services guide

Hide thumbs Also See for 7750 SR:

Table of Contents

Show, Clear, Debug Commands

Clears all spanning tree statistics for the service ID.

detected-protocols

detected-protocols {all | sap sap-id | spoke-sdp sdp-id[:vc-id]}

clear>service>id>stp

RSTP automatically falls back to STP mode when it receives an STP BPDU. The clear detected-

protocols command forces the system to revert to the default RSTP mode on the SAP or spoke SDP.

all — Clears all detected protocol statistics.

sap-id — Clears the specified lease state SAP information. See

sdp-id — The SDP ID to be cleared.

vc-id — The virtual circuit ID on the SDP ID to be cleared.

lease-state [no-dhcp-release]

lease-state ip-address ip-address [no-dhcp-release]

lease-state mac ieee-address no-dhcp-release

lease-state sap sap-id [no-dhcp-release]

lease-state sdp sdp-id:vc-id [no-dhcp-release]

clear>service>id>dhcp

This command clears DHCP lease state information.

no-dhcp-release — Specifies that the node will clear the state without sending the DHCP release

ip-address ip-address — Clears the DHCP IP address lease state information. The ip-address portion

mac ieee-address — Clears DHCP MAC address lease state information. The 48-bit MAC address

sap sap-id — Clears DHCP SAP lease state information. See

on page 1933

for command syntax.

1 — 4294967295

of the address command specifies the IP host address that will be used by the IP interface within

the subnet. This address must be unique within the subnet and specified in dotted decimal

notation. Allowed values are IP addresses in the range 1.0.0.0 – 223.255.255.255 (with support

of /31 subnets).

for the static ARP in the form aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee, and

ff are hexadecimal numbers. Allowed values are any non-broadcast, non-multicast MAC and

non-IEEE reserved MAC addresses.

on page 1933

for command syntax.

Common CLI Command Descriptions

7750 SR OS Services Guide