Alcatel-Lucent 7750 SR Manual page 1895

lease-state mac ieee-address
lease-state sap sap-id
lease-state sdp sdp-id:vc-id
Context clear>service>id>dhcp
Description Clears DHCP lease state information for this service.
Parameters ip-address — The IP address of the IP interface. The ip-address portion of the address command
ieee-address — Specifies the 48-bit MAC address for the static ARP in the form aa:bb:cc:dd:ee:ff or
sap-id — Specifies the physical port identifier portion of the SAP definition. See
sdp-id — The SDP ID to be cleared.
vc-id — The virtual circuit ID on the SDP ID to be cleared.
site
Syntax site service-id
Context clear>service>id
Description
This command clears site-specific information for the service.
Parameters
service-id — Specifies the service ID or service name up to 64 characters in length.
spoke-sdp
Syntax spoke-sdp sdp-id:vc-id ingress-vc-label
Context clear>service>id
Description
This command clears and resets the spoke SDP bindings for the service.
Parameters sdp-id — The spoke SDP ID to be reset.
vc-id — The virtual circuit ID on the SDP ID to be reset.
7750 SR OS Services Guide
specifies the IP host address that will be used by the IP interface within the subnet. This address
must be unique within the subnet and specified in dotted decimal notation. Allowed values are IP
addresses in the range 1.0.0.0 – 223.255.255.255 (with support of /31 subnets).
aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee, and ff are hexadecimal numbers. Allowed values are
any non-broadcast, non-multicast MAC and non-IEEE reserved MAC addresses.
Command Descriptions on page 1933
Values
1 — 17407
Values
1 — 4294967295
Values 1 — 2147483648
Values
1 — 17407
Values
1 — 4294967295
VPRN Clear Commands
for command syntax.
Common CLI
Page 1895