Alcatel-Lucent 7750 SR Manual page 1791

Sample Output
*A:ALA-12# show service sdp
==============================================================================
Services: Service Destination Points
==============================================================================
SdpId
------------------------------------------------------------------------------
10
40
60
100
500
------------------------------------------------------------------------------
Number of SDPs : 5
==============================================================================
*A:ALA-12#
7750 SR OS Services Guide
Label
Deliver
Delivered
Number of SDPs
Hello Time
Hello Msg Len
Hello Timeout
Unmatched Replies
Max Drop Count
Hold Down Time
TX Hello Msgs
Rx Hello Msgs
Associated LSP
List
Adm MTU Opr MTU
4462 4462
4462 1534
4462 1514
4462 4462
4462 4462
Description (Continued)
Specifies the type of delivery used by the SDP: GRE or MPLS.
Specifies the total number of SDPs displayed according to the criteria
specified.
Specifies how often the SDP echo request messages are transmitted on
this SDP.
Specifies the length of the SDP echo request messages transmitted on
this SDP.
Specifies the number of seconds to wait for an SDP echo response mes-
sage before declaring a timeout.
Specifies the number of SDP unmatched message replies.
Specifies the maximum number of consecutive SDP echo request mes-
sages that can be unacknowledged before the keepalive protocol reports
a fault.
Specifies the maximum number of consecutive SDP echo request mes-
sages that can be unacknowledged before the keepalive protocol reports
a fault.
Specifies the number of SDP echo request messages transmitted since
the keepalive was administratively enabled or the counter was cleared.
Specifies the number of SDP echo request messages received since the
keepalive was administratively enabled or the counter was cleared.
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the far end field.
If the SDP type is GRE, then the following message displays:
SDP delivery mechanism is not MPLS
IP address
10.20.1.3
10.20.1.20
10.20.1.21
180.0.0.2
10.20.1.50
VPRN Show Commands
Adm Opr Deliver Signal
Up Dn NotReady MPLS
Up Up MPLS
Up Up GRE
Down Down GRE
Up Dn NotReady GRE
TLDP
TLDP
TLDP
TLDP
TLDP
Page 1791