Alcatel-Lucent 7750 SR Manual page 1531

sdp
Syntax sdp [sdp-id | far-end ip-address] [detail | keep-alive-history]
Context show>service
Description This command displays SDP information.
If no optional parameters are specified, a summary SDP output for all SDPs is displayed.
Parameters sdp-id — The SDP ID for which to display information.
far-end ip-address — Displays only SDPs matching with the specified far-end IP address.
detail — Displays detailed SDP information.
keep-alive-history — Displays the last fifty SDP keepalive events for the SDP.
Output Show Service SDP — The following table describes show service SDP output fields:
7750 SR OS Services Guide
Default
All SDPs.
Values
1 — 17407
Default
SDPs with any far-end IP address.
Default
SDP summary output.
Default
SDP summary output.
Label
SDP Id
Adm MTU
Opr MTU
IP address
Adm
Admin State
Opr
Oper State
Deliver
Delivery
Flags
Signal
Signaling
The SDP identifier.
Specifies the desired largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without requiring
the packet to be fragmented.
Specifies the actual largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without requiring
the packet to be fragmented.
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
Specifies the desired state of the SDP.
Specifies the operating state of the SDP.
Specifies the type of delivery used by the SDP: GRE or MPLS.
Specifies all the conditions that affect the operating status of this SDP.
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP.
VLL Show Commands
Description
Page 1531