Alcatel-Lucent 7750 SR Manual page 1591

sdp-using
Syntax sdp-using [sdp-id[:vc-id] | far-end ip-address]
Context show>service
Description This command displays services using SDP or far-end address options.
Parameters
sdp-id — Displays only services bound to the specified SDP ID.
vc-id — The virtual circuit identifier.
far-end ip-address — Displays only services matching with the specified far-end IP address.
Output Show Service SDP Using — The following table describes service-using output fields.
Sample Output
*A:ALA-1# show service sdp-using 300
===============================================================================
Service Destination Point (Sdp Id : 300)
===============================================================================
SvcId
-------------------------------------------------------------------------------
1
2
100
101
102
-------------------------------------------------------------------------------
Number of SDPs : 5
-------------------------------------------------------------------------------
*A:ALA-1#
7750 SR OS Services Guide
Values 1 — 17407
Values
1 — 4294967295
Default Services with any far-end IP address.
Label
Svc ID
Sdp ID
Type
Far End
Oper State
Ingress Label
Egress Label
SdpId
300:1
300:2
300:100
300:101
300:102
The service identifier.
The SDP identifier.
Specifies the type of SDP: Spoke or Mesh.
The far-end address of the SDP.
The operational state of the service.
The label used by the far-end device to send packets to this device in
this service by this SDP.
The label used by this device to send packets to the far-end device in
this service by this SDP.
Type Far End
Mesh 10.0.0.13
Spok 10.0.0.13
Mesh 10.0.0.13
Mesh 10.0.0.13
Mesh 10.0.0.13
VPLS Show Commands
Description
Opr State I.Label
Up 131071
Up 131070
Up 131069
Up 131068
Up 131067
Page 1591
E.Label
131071
131070
131069
131068
131067