Alcatel-Lucent 7750 SR Manual page 1926

Show, Clear, Debug Commands
endpoint
Syntax endpoint [endpoint-name]
Context show>service>id
Description
This command displays service endpoint information.
Parameters
endpoint-name — Specifies the name of an existing endpoint for the service.
labels
Syntax labels
Context show>service>id
Description
Displays the labels being used by the service.
Output Show Service-ID Labels — The following table describes show service-id labels output fields:
Page 1926
Label
SDP Bind Count
Identifier
Type
AdmMTU
OprMTU
Opr
Label
Svc Id
Sdp Id
Type
I. Lbl
Description (Continued)
The number of SDPs bound to the service.
Specifies the service access (SAP) and destination (SDP) points.
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP.
Specifies the desired largest service frame size (in octets) that can be
transmitted through this SDP to the far-end ESR, without requiring the
packet to be fragmented.
Specifies the actual largest service frame size (in octets) that can be
transmitted through this SDP to the far-end ESR, without requiring the
packet to be fragmented.
The operating state of the SDP.
The service identifier.
The SDP identifier.
Indicates whether the SDP is a spoke or a mesh.
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
Description
7750 SR OS Services Guide