Alcatel-Lucent 7750 SR Manual page 1508

Show, Clear, Debug Commands
*A:MV-SR12>config>service>vprn#
When network domains are configured, the SDP egress interface state can be verified by using the following
command:
*A:Dut-T# show service sdp egressifs
===============================================================================
SDP Egress Ifs State Table
===============================================================================
SDP Id
-------------------------------------------------------------------------------
100
-------------------------------------------------------------------------------
SDPs : 1
===============================================================================
*A:Dut-Tr#
sdp-using
Syntax sdp-using [sdp-id[:vc-id] | far-end ip-address]
Context show>service
Description
This command displays services using SDP or far-end address options.
Parameters sdp-id — Displays only services bound to the specified SDP ID.
Values
vc-id — The virtual circuit identifier.
Values
far-end ip-address — Displays only services matching with the specified far-end IP address.
Default
Output Show Service SDP Using X — The following table describes show service sdp-using output fields.
Svc ID
Sdp ID
Type
Far End
Oper State
Page 1508
Network Domain
net1
1 — 17407
1 — 4294967295
Services with any far-end IP address.
Label
The service identifier.
The SDP identifier.
Type of SDP: spoke or mesh.
The far end address of the SDP.
The operational state of the service.
State
consistent
Description
7750 SR OS Services Guide