Alcatel-Lucent 7750 SR Manual page 1911

sdp
Syntax
Context
Description
Parameters
Output
7750 SR OS Services Guide
sdp [sdp-id | far-end ip-address] [detail | keep-alive-history]
show>service
This command displays SDP information.
If no optional parameters are specified, a summary SDP output for all SDPs is displayed.
sdp-id — The SDP ID for which to display information.
Default All SDPs.
Values
1 — 17407
far-end ip-address — Displays only SDPs matching with the specified far-end IP address.
Default SDPs with any far-end IP address.
detail — Displays detailed SDP information.
Default
SDP summary output.
keep-alive-history — Displays the last fifty SDP keepalive events for the SDP.
Default
SDP summary output.
Show Service SDP — The following table describes show service SDP output fields:
Label
SDP Id
Adm MTU
Opr MTU
IP address
Adm
Admin State
Opr
Oper State
Deliver
Delivery
Flags
Signal
Signaling
Last Status Change
The SDP identifier.
Specifies the desired largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without requiring the
packet to be fragmented.
Specifies the actual largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without requiring the
packet to be fragmented.
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
Specifies the desired state of the SDP.
Specifies the operating state of the SDP.
Specifies the type of delivery used by the SDP: GRE or MPLS.
Specifies all the conditions that affect the operating status of this SDP.
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP.
Specifies the time of the most recent operating status change to this
SDP.
Description
Page 1911