Show, Clear, Debug Commands
-------------------------------------------------------------------------------
6
1000
-------------------------------------------------------------------------------
Number of Bindings Found : 2
===============================================================================
*A:ALA-48#
ingress-label
Syntax
ingress-label start-label [end-label]
Context
show>service
Description
This command displays services using the range of ingress labels. If only the mandatory start-label
parameter is specified, only services using the specified label are displayed.
If both start-label and end-label parameters are specified, the services using the range of labels X
where start-label <= X <= end-label are displayed.
Use the show router vprn-service-id ldp bindings command to display dynamic labels.
Parameters
start-label — The starting ingress label value for which to display services using the label range. If
end-label — The ending ingress label value for which to display services using the label range.
Output
Show Service Ingress-Label — The following table describes show service ingress-label output
fields:
Sample Output
*A:ALA-48# show service ingress-label 2500 15000
===============================================================================
Page 1908
2:6
2:1000
only start-label is specified, services only using start-label are displayed.
Values
0, 2048 — 131071
Default
The start-label value.
Values
2049 — 131071
Label
Svc Id
Sdp I
Type
I. Lbl
E. Lbl
Number of bindings
found
Spok
6300
Spok
n/a
The ID that identifies a service.
The ID that identifies an SDP.
Indicates whether the SDP binding is a spoke or a mesh.
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
The VC label used by this device to send packets to the far-end device
in this service by the SDP.
The total number of SDP bindings that exist within the specified egress
label range.
6298
7000
Description
7750 SR OS Services Guide