Alcatel-Lucent 7750 SR Manual page 1624

Show, Clear, Debug Commands
base
Syntax base [msap]
show>service>id
Context
show>service>id>igmp-snooping
Description
This command displays basic information about the service ID including service type, description,
SAPs and SDPs.
Parameters msap — Displays management SAPs.
Output Show Service-ID Base — The following table describes show service-id base output fields:
Page 1624
Label
Service Id
Vpn Id
Service Type
Description
Customer Id
Last Mgmt Change
Adm
Oper
Mtu
Def. Mesh VC Id
SAP Count
SDP Bind Count
Identifier
Type
AdmMTU
OprMTU
The service identifier.
Specifies the VPN ID assigned to the service.
Displays the type of service.
Generic information about the service.
The customer identifier.
The date and time of the most recent management-initiated change to
this customer.
The administrative state of the service.
The operational state of the service.
The largest frame size (in octets) that the service can handle.
This object is only valid in services that accept mesh SDP bindings. It is
used to validate the VC ID portion of each mesh SDP binding defined
in the service.
The number of SAPs defined on the service.
The number of SDPs bound to the service.
Specifies the service access (SAP) and destination (SDP) points.
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP.
Specifies the largest service frame size (in octets) that can be transmit-
ted through this SDP to the far-end ESR, without requiring the packet to
be fragmented.
Specifies the actual largest service frame size (in octets) that can be
transmitted through this service to the far-end ESR, without requiring
the packet to be fragmented.
Description
7750 SR OS Services Guide