Alcatel-Lucent 7750 SR Manual page 1917

7750 SR OS Services Guide
Label
Type
Admin Path MTU
Oper Path MTU
Delivery
Admin State
Oper State
Ingress Label
Egress Label
Ingress Filter
Egress Filter
Far End
Last Changed
Signaling
Admin State
Oper State
Hello Time
Hello Msg Len
Max Drop Count
Hold Down Time
SDP Delivery Mech-
anism
Description (Continued)
Indicates whether this Service SDP binding is a spoke or a mesh.
The desired largest service frame size (in octets) that can be transmit-
ted through this SDP to the far-end router, without requiring the packet
to be fragmented.
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
Specifies the type of delivery used by the SDP: GRE or MPLS.
The administrative state of this SDP.
The operational state of this SDP.
The label used by the far-end device to send packets to this device in
this service by this SDP.
The label used by this device to send packets to the far-end device in
this service by this SDP.
The ID of the ingress filter policy.
The ID of the egress filter policy.
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
The date and time of the most recent change to this customer.
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on this SDP.
Specifies the admin. state of the keepalive protocol.
Specifies the operational state of the keepalive protocol.
Specifies how often the SDP Echo Request messages are transmitted
on this SDP.
Specifies the length of the SDP Echo Request messages transmitted on
this SDP.
Specifies the maximum number of consecutive SDP Echo Request
messages that can be unacknowledged before the keepalive protocol
reports a fault.
Specifies the amount of time to wait before the keepalive operating sta-
tus is eligible to enter the alive state.
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the Far End field.
If the SDP type is GRE, then the following message displays:
SDP Delivery Mechanism is not MPLS
Page 1917