Alcatel-Lucent 7750 SR Manual page 1790

Show, Clear, Debug Commands
If no optional parameters are specified, a summary SDP output for all SDPs is displayed.
Parameters sdp-id — The SDP ID for which to display information.
far-end ip-address — Displays only SDPs matching with the specified far-end IP address.
detail — Displays detailed SDP information.
keep-alive-history — Displays the last fifty SDP keepalive events for the SDP.
Output Show Service SDP — The following table describes show service SDP output fields:
Page 1790
Default All SDPs.
Values
1 — 17407
Default SDPs with any far-end IP address.
Default
SDP summary output.
Default
SDP summary output.
Label
SDP Id
Adm MTU
Opr MTU
IP address
Adm
Admin State
Opr
Oper State
Flags
Signal
Signaling
Last Status Change
Last Mgmt Change
Number of SDPs
Hello Time
The SDP identifier.
Specifies the largest service frame size (in octets) that can be transmit-
ted through this SDP to the far-end router, without requiring the packet
to be fragmented.
Specifies the actual largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without requiring the
packet to be fragmented.
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
Specifies the state of the SDP.
Specifies the operating state of the SDP.
Specifies all the conditions that affect the operating status of this SDP.
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP.
Specifies the time of the most recent operating status change to this
SDP.
Specifies the time of the most recent management-initiated change to
this SDP.
Specifies the total number of SDPs displayed according to the criteria
specified.
Specifies how often the SDP echo request messages are transmitted on
this SDP.
Description
7750 SR OS Services Guide