Alcatel-Lucent 7750 SR Manual page 1872

Show, Clear, Debug Commands
------------------------------------------------------------------------------
No. of Routes: 11
==============================================================================
*A:ALA-12#
neighbor
Syntax neighbor [ip-address | ip-int-name] [detail] [advertised-routes]
Context show>router>rip
Description Displays RIP neighbor interface information.
Parameters ip-address | ip-int-name — Displays information for the specified IP interface.
advertised-routes — Displays the routes advertised to RIP neighbors. If no neighbors are specified,
Output Standard Show RIP Neighbor Output — The following table describes the standard command
output fields for a RIP group.
Page 1872
Default All neighbor interfaces.
then all routes advertised to all neighbors are displayed. If a specific neighbor is given then only
routes advertised to the given neighbor/interface are displayed.
Default Display RIP information.
Label
Neighbor
Adm
Opr
Primary IP
Send Mode
Recv Mode
The RIP neighbor interface name.
Down — The RIP neighbor interface is administratively down.
Up — The RIP neighbor interface is administratively up.
Down — The RIP neighbor interface is operationally down.
Up — The RIP neighbor interface is operationally up.
The primary IP address of the RIP neighbor interface.
Bcast — Specifies that RIPv2 formatted messages are sent to the
broadcast address.
Mcast — Specifies that RIPv2 formatted messages are sent to the
multicast address.
None — Specifies that no RIP messages are sent (i.e., silent listener).
RIPv1 — Specifies that RIPv1 formatted messages are sent to the
broadcast address.
Both — Specifies that RIP updates in either version 1 or version 2
format will be accepted.
None — Specifies that RIP updates will not be accepted.
Description
7750 SR OS Services Guide