Circuit Emulation (Cem) Show Commands - Alcatel-Lucent 7750 SR Manual

Circuit Emulation (CEM) Show Commands

CEM CEM
egress-label
Syntax
Context
Description
Parameters
Output
7750 SR OS Services Guide
egress-label egress-label1 [egress-label2]
show>service
This command displays services using the range of egress labels. If only the mandatory egress-label1
parameter is specified, only services using the specified label are displayed.
If both egress-label1 and egress-label2 parameters are specified, the services using the range of labels
X where egress-label1 <= X <= egress-label2 are displayed.
Use the show router ldp bindings command to display dynamic labels.
egress-label1 — The starting egress label value for which to display services using the label range. If
only egress-label1 is specified, services only using egress-label1 are displayed.
Values
0, 2049 — 131071
egress-label2 — The ending egress label value for which to display services using the label range.
Default
The egress-label1 value.
Values
2049 — 131071
Show Service Egress Command Output — The following table describes show service
egress label output fields.
Label
Svc Id
Sdp I
Type
I. Lbl
E. Lbl
Number of bindings
found
Sample Output
*A:ALA-48# show service egress-label 3000 10000
===============================================================================
Martini Service Labels
===============================================================================
Svc Id Sdp Binding
The ID that identifies a service.
The ID that identifies an SDP.
Indicates whether the SDP binding is a spoke or a mesh.
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
The VC label used by this device to send packets to the far-end device
in this service by the SDP.
The total number of SDP bindings that exist within the specified egress
label range.
Type I.Lbl
Description
E.Lbl
Page 1907