Alcatel-Lucent 7750 SR Manual page 1642

Show, Clear, Debug Commands
l2pt
Syntax l2pt disabled
l2pt [detail]
Context show>service>id
Description This command displays Layer 2 Protocol Tunnel (L2-PT) route information associated with this
service.
Parameters
disabled — Displays only entries with termination disabled. This helps identify configuration errors.
detail — Displays detailed information.
Output Show L2PT Fields — The following table describes show L2PT output fields:
Page 1642
Label
Service id
L2pt-term enabled
L2pt-term dis-
abled
Bpdu-trans auto
Bpdu-trans dis-
abled
SAPs
SDPs
Total
SapId
L2pt-termination
Admin Bpdu-trans-
lation
Oper Bpdu-
translation
SdpId
Displays the 24 bit (0..16777215) service instance identifier for the
service.
Indicates if L2-PT-termination and/or Bpdu-translation is in use in this
service by at least one SAP or spoke SDP binding. If in use, at least
one of L2PT-termination or Bpdu-translation is enabled.
When enabled it is not possible to enable STP on this service.
Indicates that L2-PT-termination is disabled.
Specifies the number of L2-PT PDU's are translated before being sent
out on a port or sap.
Indicates that Bpdu-translation is disabled.
Displays the number of SAPs with L2PT or BPDU translation enabled
or disabled.
Displays the number of SDPs with L2PT or BPDU translation enabled
or disabled.
Displays the column totals of L2PT entities.
The ID of the access point where this SAP is defined.
Indicates whether L2pt termination is enabled or disabled.
Specifies whether Bpdu translation is administratively enabled or dis-
abled.
Specifies whether Bpdu translation is operationally enabled or dis-
abled.
Specifies the SAP ID.
Description
7750 SR OS Services Guide