Alcatel-Lucent 7750 SR Manual page 1744

Show, Clear, Debug Commands
Page 1744
Label
Egress Label
Ingress Filter
Egress Filter
Far End
Last Changed
Signaling
Admin State
Oper State
Hello Time
Hello Msg Len
Max Drop Count
Hold Down Time
SDP Delivery Mech-
anism
Number of SDPs
Service Access Points
Service Id
Port Id
Description
Encap
Admin State
Oper State
Last Changed
Description (Continued)
The label used by this device to send packets to the far-end device in
this service by this SDP.
The ID of the ingress filter policy.
The ID of the egress filter policy.
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
The date and time of the most recent change to this customer.
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on this SDP.
Specifies the operating status of the service.
The current status of the service.
Specifies how often the SDP echo request messages are transmitted on
this SDP.
Specifies the length of the SDP echo request messages transmitted on
this SDP.
Specifies the maximum number of consecutive SDP Echo Request mes-
sages that can be unacknowledged before the keepalive protocol reports
a fault.
Specifies the amount of time to wait before the keepalive operating sta-
tus is eligible to enter the alive state.
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the far-end field.
If the SDP type is GRE, then the following message displays:
"SDP Delivery Mechanism is not MPLS"
The total number SDPs applied to this service ID.
The service identifier.
The ID of the access port where this SAP is defined.
Generic information about the SAP.
The value of the label used to identify this SAP on the access port.
The desired state of the SAP.
The operating state of the SAP.
The date and time of the last change.
7750 SR OS Services Guide